Alpha AWP-158 Instruction Manual page 14

1. During operation, be sure to wear personal safety equipment.
2. If you accidentally drop the polisher, do not use the polisher until
checking that it is not cracked, deformed, or damaged. Check the
polishing disc as well.
Before plugging the power supply cord into the power outlet, make sure the switch is turned
OFF. If you plug in the power supply cord without realizing the switch is turned ON, the
polisher will start and it may cause an accident.
1. Water valve operation
– Turn ON the water valve lever to allow water to flow through the polisher.
2. Switch operation
– Push the switch lever forward to start the polisher. Wait until the motor has
reached its constant RPM (revolutions per minute).
3. Polishing procedure
– When the polishing disc comes into contact with the workpiece make contact
slowly.
– Proceed polishing in a desired pattern using all polishing discs in recommended
sequence.
4. Applying force onto the polisher
– Do not apply more force onto the polisher than the force created by the w e i g h t
of the polisher itself. The polishing disc is designed to work properly under light
weight.
– Applying excessive force or pressure may damage the disc and could shorten
the machine's service life. Such action will decrease rotation speed, which reduces the
efficiency of polishing action and jeopardize polishing results.
5. Precautions immediately after use.
– After using the polisher, turn OFF the switch.
– Once the disc stops rotating completely, put the polisher in a safe place. It may
cause a unexpected accident if you touch the disc before the disc stops rotating.
14
DANGER!
CAUTION!