Alpha AWP-158 Instruction Manual page 12

Be sure to tighten any loose screws and applicable accessories.
1. Backer Pad Attachment
Procedures (Figure–1)
a) Place the polisher upward to attach the
backer pad onto the spindle.
b) Slide the wrench into provided slot located
in the front of polisher to lock the spindle
and proceed tightening the backer pad.
c) Remove the wrench.
d) Center and attach the polishing disc onto the backer pad by securely pressing onto
the attachment.
e) Cut rubber guard according to your needs.
Note: If using the Alpha
applications together with the flat polishing caster, a "SPACER
RING" may be needed
AWP and Twistouch Adapter to level the height of the Twistouch
Turbo abrasives with the flat polishing caster.)
2. Attaching the water hose. (Figure–3)
a) Attach the polisher water hose fitting to a
regular garden hose by tightening the fitting.
The polisher water hose fitting will fit on any
garden hose.
3. Attaching the C handle (handle A).
( Figure -4) The C handle (handle A) delivers
better control and stability of the polisher when
used with any of the following accessories;
flat polishing caster, core drill bit or Twistouch
Turbo.
a) Slide the C handle (handle A) onto the gear
case and match the holes pattern.
b) Insert provided two screws (M8X16) into the
holes and tighten them to securely attach
the C handle (handle A) onto the gear case.
Note: Do not overtighten the two screws
12
WARNING!
Twistouch Turbo system for flat area
®
to be placed between the spindle of
(M8X16). Doing
Figure-2
Figure-3
Figure-4