Mitsubishi XL30 XL25 SL25 User Manual page 34

How to set the grade
Use the ASCII codes to set the grade for setting data. Please refer to the table below for the HEX code.
ASCII '+' '–'
HEX 2Bh 2Dh
[Example 1] When setting the AUTO POWER ON to ON. (Figures and symbols enclosed in quotation marks
are ASCII codes.):
Sending commands
from the PC, etc.
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
The data code of CONTRAST and BRIGHTNESS consists of the difference data between R and G, the main data, and
the difference data between B and G.
[Example 2] When setting the difference data between R and G to +10, the main data to 0, and the difference
data between B and G to -5. (Figures and symbols enclosed in quotation marks are ASCII codes.):
Sending commands
from the PC, etc.
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
[Example 3] When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed in
quotation marks are ASCII codes.)::
Sending commands
from the PC, etc.
30 30 53 0D
'0' '0' 'S' ' '
'0' '1' '2' '3'
30h 31h 32h 33h
'
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
'
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'P' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
30 30 53 2B 31 30 0D
'0' '0' 'S' '+' '1' '0' '
'4' '5' '6' '7'
34h 35h 36h 37h
Status code from
the projector
'
Status code from
the projector
Status code from
the projector
'
5
'8' '9'
38h 39h
Description
Command for setting the
AUTO POWER ON to ON
Command receipt confirmation
(Command echo back)
Description
Command for setting the
picture control
Command receipt confirmation
' (Command echo back)
Description
Command for checking
the TINT setting
Check result (+10)