Troubleshooting - Zanussi ZRB33104WA User Manual

Caution! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those

Troubleshooting

Caution! Before troubleshooting,
disconnect the power supply.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Problem
The appliance is noisy.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
There is too much frost
and ice.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
22
Possible cause
The appliance is not supported
properly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
Products are not wrapped properly.
The door is not closed correctly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The Temperature regulator may be
set incorrectly.
The door is not closed correctly.
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Check if the appliance stands stable
(all the four feet should be on the
floor).
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Wrap the products better.
Refer to "Closing the door".
Set a higher temperature.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Solution
www.zanussi.com