Subscribe to Our Youtube Channel
Related Manuals for MOTA JETJAT Nano-C
Summary of Contents for MOTA JETJAT Nano-C
- Page 1 AGES 8+ OWNER’S MANUAL JETJAT Nano-C For Owner’s Manual updates, warranty information, instructional videos, and support, please visit: www.mota.com/jetjat-nano-c...
-
Page 2: Table Of Contents
Table of Contents Fly Safely! In the Box Battery Installation and Charging Charging the JETJAT Nano-C Pre-flight Operation and Control Response Levels Aerial Tumbling Photo and Video Trim Adjustment Accelerometer Calibration Low Battery and Standby Function Troubleshooting Tips Specifications Lithium Battery Safety Guide... -
Page 3: Fly Safely
- Know and comply with laws and regulations respecting drone use in your area. - Keep hands away from rotors when drone is switched on. - Fly within transmitter range, which is 75 feet. Download your SAVE-A-DRONE Flight Safety Poster @ mota.com/jetjat... -
Page 4: In The Box
In the Box JETJAT Nano-C Micro Power Switch/Charging Cable (available）... - Page 5 TRANSMITTER Power BLADE USB CHARGING CABLE...
-
Page 6: Battery Installation And Charging
2. Install two “AAA” batteries 3. Close cover Note: Check that both batteries’ positive and negative terminals are installed correctly. Charging the JETJAT Nano-C Pre-flight 1. Turn ON the transmitter. 2. Pull the throttle all the way back toward the user. -
Page 7: Operation And Control
Operation and Control Caution: Please operate the control stick slowly when flying your drone. During flying, the drone may lose altitude when maneuvering. Therefore, you may need to add more power to keep the drone flying at a given height. Right-Handed Left-Handed - Throttle: Ascent and Descent... -
Page 8: Response Levels
Response Levels Press the left throttle down to traverse through three control levels. - Moderate: Single “beep” - moderate control responsiveness - High: Double “beep”- high control responsiveness - Maximum: Triple “beep” - highest control responsiveness... -
Page 9: Aerial Tumbling
Aerial Tumbling JETJAT Nano-C can do aerial flips. - Flips can be performed in any one of 4 horizontal directions: left, right, forward, or backward. - In order to better carry out aerial flips, ensure the drone is at least one meter above the ground. -
Page 10: Trim Adjustment
Trim Adjustment Accelerometer Calibration If the drone appears unstable or drifts to one direction, you need to calibrate the accelerometer. 1. After pairing the drone and transmitter, place the drone on a level surface. 2. Set Sensitivity to Maximum and pull the throttle all the way back and left while pushing the ascend/descend aileron all the way forward to the upper left. -
Page 11: Low Battery And Standby Function
Low Battery and Standby Function Low Battery Voltage When the battery voltage is running low, the four LED indicators on the drone will flash. Lower the flying height and land the drone as soon as possible to avoid damaging the drone. Turn off the drone power and recharge. Standby Function After about 8 minutes of inactivity, the drone will automatically turn off. -
Page 12: Specifications
Specifications Dimensions L x W x H: 32 x 32 x 22 mm Weight: 0.6 oz Camera: 0.3 megapixels Range: Approximately 75 feet Flight Time: Approximately 2.5 to 4 minutes Charging Time ( 120 mAh, 3.7 V): Approximately 25 minutes Note: Flight time, range and charging time may vary depending on flight conditioins and battery condition. -
Page 13: Lithium Battery Safety Guide
This product carries a 90-day Limited Warranty against defects in materials and workmanship. The Limited Warranty is valid only if defect(s) are reported to MOTA Technical Support before the drone’s first flight. MOTA is not responsible for any damage to the product and/or accessories other than defects in materials and workmanship.
Need help?
Do you have a question about the JETJAT Nano-C and is the answer not in the manual?
Questions and answers