Indicators - Mitsubishi Electric EX100U User Manual

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your
dealer.
Normal condition
POWER
STATUS
Steady
Off
red
Blinking
Steady
green
green
Steady
Steady
green
green
Abnormal condition
POWER STATUS
Steady
green
or
Blinking orange
Steady red
Steady red
Blinking green
Steady
Blinking green/red
green
Blinking red
Steady red
Steady red
Steady red
Off
Blinking
green/red
Steady
or
Blinking
green/red
Blinking
EN - 26
POWER indicator
CONDITION
Stand-by
Lamp stand-by (about 1 minute)
The power is on. (Normal condition)
CONDITION
Abnormal temperature
• The ventilation grilles is clogged with dust or dirt.
• The room temperature is high.
The protection circuit is working or the lamp is in an
abnormal condition.
The lamp operation time exceeds the time elapsed until the
lamp shutdown notice while the power is on. (See page 22.)
The lamp operation time exceeds the time elapsed until the
lamp shutdown notice while the power is off. (See page 22.)
The lamp operation time exceeds the time elapsed until the
lamp shutdown. (See page 22.)
The lamp cover isn't closed.
Abnormal.
STATUS indicator
POWER STATUS
NOTE
The POWER button cannot be used to
switch between on and off.
POSSIBLE SOLUTION
• Clean the ventilation grilles.
• Relocate the projector to a cooler place.
• Wait until the STATUS indicator goes out,
then press the POWER button.
• If the above solution is not effective, replace
the lamp.
Replace the lamp.
Change with a new lamp if this problem recurs.
Close the cover correctly.
Contact your dealer.