Advertisement
How to set the grade
Use the ASCII codes to set the grade for setting data. Please refer to the table below for the HEX code.
ASCII
'+'
'–'
HEX
2Bh
2Dh
[Example 1]
When setting the AUTO POWER ON to ON. (Figures and symbols enclosed in quotation marks
are ASCII codes.):
Sending commands
from the PC, etc.
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
The data code of BRIGHTNESS consists of the difference data between R and G, the main data, and the difference
data between B and G.
[Example 2]
When setting the difference data between R and G to +10, the main data to 0, and the difference
data between B and G to -5. (Figures and symbols enclosed in quotation marks are ASCII codes.):
Sending commands
from the PC, etc.
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'Q' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
[Example 3]
When checking the TINT setting (when the TINT is set to +10). (Figures and symbols enclosed in
quotation marks are ASCII codes.)::
Sending commands
from the PC, etc.
30 30 53 0D
'0' '0' 'S' '
'
• To set TINT at 0, enter +00. (-00 is invalid.)
'0'
'1'
'2'
'3'
30h
31h
32h
33h
'
30 30 41 50 4F 4E 31 0D
'0' '0' 'A' 'P' 'O' 'N' '1' '
'
30 30 50 2B 31 30 2B 30 30 2D 30 35 0D
'0' '0' 'Q' '+' '1' '0' '+' '0' '0' '-' '0' '5' '
30 30 53 2B 31 30 0D
'0' '0' 'S' '+' '1' '0' '
'4'
'5'
'6'
'7'
34h
35h
36h
37h
Status code from
the projector
'
Status code from
the projector
Status code from
the projector
'
5
'8'
'9'
38h
39h
Description
Command for setting the
AUTO POWER ON to ON
Command receipt confirmation
(Command echo back)
Description
Command for setting the
picture control
Command receipt confirmation
'
(Command echo back)
Description
Command for checking
the TINT setting
Check result (+10)
Advertisement
