Mitsubishi WS - 48313 Owner's Manual page 28

Use of the Remote Control with Other A/V Products
CABLE/DBS/DTV VCR
DVD
TV
1.
3.
DVD Player Codes
DVD/LDP brand
Code to enter:
Mitsubishi 003
JVC 257
Panasonic 250
Philips 258, 253, 272
Pioneer DVD 252
Samsung 261
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your
DVD or LDP.
CABLE/DBS/DTV VCR
TV
1.
3.
A/V Receiver Codes
Audio brand Code to enter:
Mitsubishi A/V receiver
010, 015, 011, 012,
and/or CD player
013, 014
234, 235, 236, 245,
Denon
246, 359
Harman Kardon
215, 223, 242
JVC
233, 232
Kenwood
208, 200
Marantz
224, 350
Onkyo
209, 214, 240, 247
Pioneer
205, 207
Sony
222, 249
Technics
218, 219, 221
Yamaha
202, 201, 243, 244
To reset to default code, enter 000
Figure 5. Programming the remote to control your
A/V receiver.
If the slide switch is set to TV when you enter an A/V
receiver code, VOLUME and MUTE will control
the A/V receiver rather than the TV. To return
volume and mute control to the TV, set the slide
switch to TV, press and hold POWER and enter 000.
28
AUDIO
POWER
2.
If your
DVD
code is not
listed here,
please see
page 66
for a
complete
listing.
DVD
AUDIO
2.
POWER
If your
audio
code is not
listed here,
please see
page 66
for a
complete
listing.
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. If you enter a code from the AUDIO chart
while the slide switch is set to TV, the volume and
mute functions change to match the A/V receiver.
This is useful when using an A/V receiver with the
TV all the time. In all other cases, only one of the
below devices is allowed for each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
either 010 or 011. Plug the CD player power cord into a
switched outlet on the back of your A/V receiver. Pressing
the POWER button turns On the A/V receiver, along
with the CD player. In the audio position, for some
CD players, the transport controls (FF, Play, Rew, etc.)
operate the CD player.
Some manufacturers may change their products, or
they may use more than one remote control system.
If this is the case, your remote control may not be
able to operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.