Cable Box To A Vcr (Audio & Video) - Mitsubishi Electric WD-52825 Owner's Manual

Connecting a Cable Box to a VCR (Audio & Video)
Cable Box to a VCR (Audio & Video)
Figure 6
A two-way RF splitter, 4 coaxial cables, right and left audio
cables and an S-Video or Video cable are required. These are
not included with the TV.
1. Connect the incoming cable to IN on the RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the cable box back
panel.
3. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
4. Connect one coaxial cable from OUT on the cable
box to ANTENNA IN on the VCR back panel.
5. Connect one coaxial cable from ANTENNA OUT on
the VCR back panel to ANT-2 AUX on the TV back
panel (optional).
6. To use the TV speakers with the VCR, connect a
set of audio cables from AUDIO OUT on the VCR
back panel to INPUT-1 AUDIO-LEFT (MONO) and
AUDIO-RIGHT on the TV back panel. The red cable
connects to the R (right) channel and the white
3.
5.
1.
Incoming
3.
Cable 2.
Cable Box
back panel section
2.
IN
4.
OUT
Figure 6. Connecting a VCR to a Cable Box
9.
8.
TV back panel section
IEEE1394
INPUT/OUTPUT
PC
IR EMITTER
VGA/SVGA/XGA/
NetCommand R
720p
AUDIO AUDIO
60 Hz MONITOR MONITOR
VIDEO VIDEO S-VIDEO S-VIDEO
R R L(MONO) L(MONO) OUTPUT OUTPUT
L
DVI
L AUDIO 2
Analog Audio
R R
ANT-2
ANT-1
MAIN AUX AUDIO/VIDEO 1
PC- AUDIO/VIDEO 1
AUDIO
DTV/ DTV/
CABLE/ CABLE/
INPUT-1 INPUT-1
VHF/ VHF/
UHF UHF
HDMI ANT-1 ANT-2 INPUT-2
PC-
M-LINK MAIN AUX
INPUT
M-LINK
CONTROL/
RS-232C
DIGITAL
AUDIO
6.
7.
Attach only one cable type
cable connects to the L (left) channel. If your VCR
is mono (non-stereo), connect only the white (left)
cable.
7. Connect either an S-Video or Video cable from
VIDEO OUT on the VCR back panel to INPUT 1
VIDEO on the TV back panel. Only one type of
video cable should be connected. S-Video is
recommended, if available.
8. For NetCommand® controlled recordings, connect
a set of audio cables from AUDIO IN on the VCR
back panel to MONITOR OUTPUT AUDIO/VIDEO 1
AUDIO-LEFT (MONO) and AUDIO-RIGHT on the TV
back panel. The red cable connects to the R (right)
channel and the white cable connects to the L (left)
channel.
9. Complete the NetCommand controlled recordings
connections by connecting a Video cable from
VIDEO IN on the VCR back panel to MONITOR
OUTPUT AUDIO/VIDEO 1 on the TV back panel.
8.
VCR back panel
�� �����
If your VCR has a video channel
6.
or RF ON/OFF switch, set it to OFF.
7.
S-Video
7. 9.
recommended
if available
Note:
NetCommand®
will assume
your VCR is
connected to
inputs as shown
on this page.
4.
If you use any
5.
other inputs for
your VCR or
add a second
VCR, this
change must
match in the
NetCommand
system.
See Edit
NetCommand...
in Chapter
3 for more
information.
23