Mitsubishi VS-50111, VS-60111, WT-42311, WS-48311, WS-55311, WS-65311, WS-55411, WS-65411, WS-73411 Owner's Manual page 15

Special Setups: A/V Equipment
VCR:
Connect the cables to the TV as directed
on page 17, with one exception. Connect the
audio output connection to the appropriate input
on the back of the A/V receiver (as shown in
Table 1).
DVD:
Connect the cables as directed on page
19 (using the COMPONENT-1 input), with one
exception. Connect the digital audio output
connection on the DVD player to the
appropriate digital input on the back of the
digital A/V receiver (as shown in Table 1).
DTV:
Connect the cables as directed on pages
20-21, with one exception. Connect the digital
audio output connection on the DTV receiver to
the appropriate digital input on the back of the
digital A/V receiver (as shown in Table 1).
A/V Receiver:
Connect as directed on page
18, with two additions. Use an S-Video cable
in step 1 if you have an S-Video VCR. The
TV outputs should be connected to the A/V
receivers input marked TV.
•Auto Standby:
ON (See your A/V receiver's
Owner's Guide for this procedure). For all TV
use, the sound will come from the A/V receiver.
Not available with all A/V receivers.
Samples of various brands of AV Receivers are shown below.
Brand Model
Mitubishi M-VR1000/MR800
Mitsubishi M-RVR900/M-VR700 TV
Denon AVR2800
JVC RX-888V
Kenwood VR-2080
Onkyo TX-DS575
Pioneer VSX-21
Sony STR-DE825
Yamaha RX-V2095
Table 1. A/V receiver back panel input table (Connections vary by model; you may need to test individually)
(For System 4 Home Theater IR Control)
•Digital Input Assignment for DVD:
the digital input you used for your DVD player
to the A/V receiver's DVD input selector. This
procedure is explained in your A/V receiver's
Owner's Guide.
•Digital Assignment for DTV:
digital input you used for DTV to the A/V
receiver's DTV input selector. This procedure is
explained in your A/V receiver's Owner's Guide.
Infrared Emitter:
22.
Special Setups: TV
To correctly setup System 4 use the following
settings
Remote Control, pages 26-27.
•Set the slide switch to the TV position and
follow the programming instructions using the
A/V receiver code appropriate for your A/V
receiver, page 27 (Figure 5).
The products listed at the top of this column connect to the
below listed inputs on the back of the appropriate A/V receiver.
TV/Cable
SAT/DBS/DTV
TV VCR 2
CABLE/DBS
TV/DBS VCR 2
TV VIDEO 2
AV AUX LD
VIDEO 3 VIDEO 2
TV/SAT VIDEO 2
TV/DBS VIDEO 2
TV/DBS VCR 2
Connect as shown on page
•TV Speakers:
OFF
•Audio Output:
Fixed
See Audio Video Menu, page 31.
•TV Inputs Appropriately Named
See Input Assignment Menu, page 31.
VCR DVD
VCR 1 DVD
VCR DVD
VCR 1 DVD/LD
VCR 1 DVD
VIDEO 1 DVD
VIDEO 1 DVD
VCR 1 DVD/LD
VIDEO 1 DVD/LD
VCR 1 DVD/LD
Part ll: Installation
Assign
Assign the
15
15