Mitsubishi Electric TM WD-62827 Owner's Manual page 118

Appendix J: Troubleshooting, continued
Picture
Symptom
1. PIP does not display a picture.
2. CableCARD channel is not shown as PIP image
when CableCARD channel is the main image.
3. There is a large black or gray rectangle on the
screen.
4. You cannot see a picture when playing a VHS
tape.
5. When viewing a stopped VCR, white lines are
rolling on the screen.
6. Screen is black when trying to view digital
channels or IEEE 1394 device.
7. A program recorded on your widescreen TV is
distorted when played on a 4:3 TV.
8. Cannot see a picture from a DV Camcorder.
9. DVCR analog/digital problems.
Indicators
Symptom
1. Lamp indicator light is a constant red.
2. Lamp indicator light is a constant yellow.
3. Lamp indicator light is a flashing yellow.
4. Status indicator light is a constant yellow.
5. Status indicator light is a constant/flashing red.
Remarks
• Make sure the V-Chip lock is off.
• Not all inputs can be displayed as a PIP.
Due to the limitations of unidirectional CableCARD service, only one
scrambled CableCARD channel can be tuned, viewed, or recorded at a
time.
The TV's analog closed captioning has been set to "text" mode in the
Captions menu. Turn off because there is no text information being
broadcast.
• Display the Device Selection menu and select the correct VCR.
• Check your VCR's owner's guide for further troubleshooting.
• Turn off video mute for the VCR.
• Begin playing the tape.
• Change the VCR input to the antenna input.
The PerfectColor™ color balance has been incorrectly set. Press VIDEO
repeatedly until you see the PerfectColor option and press ENTER.
TV was set to Anamorphic when program was recorded. Record
programs in Cropped mode if playing back on a 4:3 TV. Open the
Record menu and select Cropped before making such a recording.
DV formatting was not detected during automatic discovery, so you must
specify it manually. Open the Edit NetCommand screen, select Change,
then select the camcorder, Add, and in the Name for 1394 Device
screen, check mark the DV box.
If the tape is currently playing but no picture displays, there may be a
mismatch of the media with the display. Press DEVICE to display the
Device Selection menu. Press ENTER for the DVCR device. If digital is
selected, try analog, or if analog is selected, try digital.
Remarks
Turn the TV off for at least 2 minutes. Turn back on. If light is still red,
the lamp has failed. Replace it. See Appendix G for lamp replacement
information.
Lamp may fail soon. Purchase a new lamp. See Appendix G for lamp
replacement information.
Lamp cover door is open or lamp cartridge is not secure. See Appendix
G for lamp replacement information.
Room temperature has exceeded proper levels. Cool the room.
Service is required. Contact your dealer or a Mitsubishi Authorized
Service Center to arrange for a service evaluation. Listings of Mitsubishi
Authorized Service locations can be obtained from our web site, www.
mitsubishi-tv.com or by calling 1-800-332-2119.
Appendices 117