ViewSonic CDE3203 User Manual page 43

Remote 8
Control
Setup wizard 8
Tiling-Mode 8
Tiling- 8
Compensation
Tiling-H by V 8
Monitors
Tiling-Position 8
Date 8
Time 8
Restore default 8
Note:
1. Behavior at lock modes
Lock Mode
Button Lock
MENU Lock
POWER Lock
Remote control disable Lock the keys on RCU, but keep the buttons of front panel workable.
s B 42
s C 43
s P 50
s Q 51
s R 52
s S 53
s V 56
s W 57
s ~ 7E
Behavior
1. Lock all buttons of front panel and RCU, except for "Power"
2. All the SET functions should be workable via RS32, even the ones with
according hot key in RCU like Mute,...etc.
1. Lock "MENU' key of front panel and RCU
2. The Factory and Hospitality modes should not be blocked for the model
using MENU-combined key to enter these two modes. Alternative
approach will be indicated separately if any limitation by model.
1. Lock "POWER" key of front and RCU.
2. The SET_POWER on/off should be workable via RS232, but does not
mean the POWER lock will be released under this case.
3. Can not be un-locked by reset in OSD setting
4. Will auto AC power-on in power-lock
5. Under power-lock, the set will not enter power saving when no PC
signal and neither not turn off when no other video signals after 15min.
32
000: Disable Disable: RCU has no
001: Enable effect on HDTV.
002: Pass through Enabled: RCU controls
the HDTV.
This is the power up
default on the HDTV.
Pass through: RCU has
no effect on HDTV and all
RCU command codes are
transmitted to FC via the
RS232 port.
000: Disable (for TV)
001: Enable Disable: to skip the initial
setup wizard
000: OFF (for DS)
001: ON
000: OFF (for DS)
001: ON Bezel width
compensation
01x~09x: H (for DS)
0x1~0x9: V 1. 2
nd
monitors
2. 3 digital for V monitors
rd
001~025 (for DS)
Copy the screen of
Position# to identified
display
0xx: Year For specific models only
1xx: Month+Day
(See example in
Note)
0xx: Hour+Min For specific models only
10x: Sec
(See example in
Note)
000 Resets HDTV to factory
setting
digital for H