Connecting An Antenna To A Cable Box And Vcr; Connecting Audio/Video To The Cable Box Or Vcr; Connecting Audio/Video To A Cable Box Or Vcr - Mitsubishi WS-65315A Owner's Manual

Connecting an Antenna to a Cable Box and VCR,

Connecting Audio/Video to the Cable Box or VCR

Note: The TV back panel and connections shown here are for reference only and may vary by model.
Contact your local cable or satellite provider or refer to the cable box or satellite Owner's Guide for
instructions on optimal connections to this TV.
�������� �����
�
����� ���
���� ���������
�
���
��� ���� �����
�
��
�������
���
Figure 5. Connecting the VCR with cable box.
Additional connection cables are not
provided with the TV. They should be
available at most electronic stores.
���
�����
�
���
��� ���� �����
��
�
�������
�� ���� ��� ��� � �����
������� �� �� ������
���
������� ��� �� ����
Figure 6. Connecting the VCR Audio/Video.
16
�� ���� ����� �������� �������
� � � �
� � � � � �� � � � � � �
�
�
�
��
����� �� ����� ���
����� ���
� �
�
�
�
� � � � � � �
� �
�
�� ���� �����
�������� �������
� � � � �
�
�
������������ �� ����������
�������
������ ����
�
��� ����� ����
� � � ��
������
��� � �
������
����� �
� ��� �
����� ��� ����� �� ����� ���
�����
� � �����
�
�
�
�������
���
�
�
Cable Box
(Figure 5)
1. Connect the incoming cable to ANT-A on the TV
back panel.
Connect three coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to IN
on the back of the cable box.
3. One from OUT on the back of the cable box to
ANTENNA IN on the VCR back panel.
4. One from ANTENNA OUT on the VCR back
panel to ANT-B on the TV back panel.
�����
Note: For best performance, please see Composite
Video with Audio or S-Video with Audio,
below.
Composite Video with Audio or
S-Video with Audio
(Figure 6)
1. Connect a video or an S-Video cable from
VIDEO OUT on the VCR back panel to VIDEO or
S-VIDEO, INPUT-1 or INPUT-2 on the TV back
panel.
2. Connect a set of audio cables from AUDIO OUT
on the VCR back panel to AUDIO INPUT-1 or
INPUT-2 on the TV back panel, matching the
input used in step 1.
• The red cable connects to the R (right) channel
�
������
• The white cable connects to the L (left) channel
����
���
�����
����
�
If your VCR is mono (non-stereo), connect only
the white (left) cable.
You may connect to the S-VIDEO or VIDEO
terminal but not to both.
(Recommended)