Mitsubishi WS-65908 Owner's Manual page 27

Programming the Remote Control: To Control Other A/V Products
VCR
CABLE/DBS/DTV DVD
TV AUDIO
1
3 DVD/LDP Player Codes
DVD/LDP brand Code to enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016, 017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD/
LDP.
VCR
CABLE/DBS/DTV DVD
TV
AUDIO
1
3 A/V Receiver Codes
Audio brand
Code to enter:
Mitsubishi A/V receiver
Set M-VR1000 or M-VR800 to 015
and/or CD player
Set M-VR900 or M-VR700 to 010
Denon 234, 235, 236
Kenwood 200, 208
JVC 232, 233
Onkyo 209, 214
Pioneer 205, 207
Sony 222
Yamaha 201, 202
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V
receiver.
If the slide switch is set to TV when
you enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
After entering the correct codes in each posi-
tion of the remote control, use the slide
switch to select which product will respond
POWER
when an operational button is pressed. If
you enter a code from the AUDIO chart
2
while the slide switch is set to TV, the
volume and mute functions change to match
If your
the A/V receiver. This is useful when using
DVD
code is not
an A/V receiver with the TV all the time.
listed here,
please see
In all other cases, only one of the below
page 62
for a
devices is allowed for each slide switch posi-
complete
tion.
listing.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
POWER
VCR position:
2
VCR
DVD position:
If your
DVD
audio
LD Player
code is not
listed here,
please see Audio position:
page 62
A/V receiver
for a
complete
Mitsubishi CD player
listing.
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, Play, Rew, etc.) in the audio position will
operate the CD player.]
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
Part III: Setup
[If you have a Mitsubishi A/V
27
27