Advertisement
Loosely tighten all hardware until the antenna is completely assembled and then
tighten securely.
1. To assemble the two halves, insert the (4) #8-32 machine screws through the front. Secure with the keps
nuts on the back (see Figure 3-3).
2. Place the sub-relector on the front of the feed and secure it with the #6 x
Figure 3-4. Securing the Sub-Reflector on the Front of the Feed.
NOTE
Figure 3-3. Securing the Antenna with the Keps Nuts.
24-DBI DIRECTIONAL ANTENNA
1
⁄
" stainless screw. See Figure 3-4.
2
Feed
Sub-reflector
5
Advertisement
