Download Print this page

IHP WINSLOW PS40 Quick Start Manual

Table of Contents

Need help?

Do you have a question about the WINSLOW PS40 and is the answer not in the manual?

Page 2 QUICK START GUIDE - WINSLOW™ PS40 PELLET STOVE WARNING Before you set up or operate your stove, review all safety, installation, and operation instructions in your “Installation and Operation Manual.” USING THIS GUIDE This guide contains 5 easy steps to help you learn more about using your new Winslow™...
Page 3: Manual Operation
3. Check to make sure the stove remains lit “Start” button to 4. If the flame goes out, press the re-ignite the stove STOPPING THE WINSLOW PS40 PELLET STOVE “OFF” position 1. Turn the control board dial to the (The blowers will automatically turn off once the stove...
Page 4: Damper Adjustment
DAMPER ADJUSTMENT The Winslow™ PS40 pellet stove is equipped with a damper adjustment which is used to fine tune combustion. Although every unit is test burned and calibrated at the factory, periodic adjustment may be necessary at times to compensate for variables such as fuel, venting, climate, altitude, and maintenance intervals. OPENING THE DAMPER Opening the damper increases the amount of combustion air.
Page 5 CLEANING AND MAINTENANCE SCHEDULE (CONTINUED) In addition to the regular maintenance procedures described below, the “Installation and Operation Manual” out- lines yearly service that should be performed by a qualified technician. Burn Pot Heat Exchanger Keeping the heat exchanger tubes clean The burn pot should be checked will maximize the heating for clinkers prior to operating...