Troubleshooting - Inguiti Max Speed Instruction Manual

Troubleshooting

Transmitter and Inguity® Max Speed Do Not Pair
If you have more than one Inguity® Max Speed, ensure you are not pairing them at the same time. Although
up to 4 drones can be paired total, only one can be paired to the same remote at any given time. Pair one,
then turn on the second drone and pair that one. Continue this process until up to 4 devices are paired.
Turn the transmitter off. Push the throttle/accelerator stick (left stick) all the way down. Turn your controller
back on. The indicator light should be blinking. Push your throttle 100% up, then back down to 0%. A single
beep will occur and your unit should be paired. In some cases, removing the battery from the quadcopter
and repeating the steps are required.
Inguity® Max Speed Won't Perform Flips
1) Battery power is too low to execute flips.
2) Controller did not properly pair with quadcopter.
3) 3D Eversion button was not pressed (continuous beeps until flip direction chosen).
Gyro is Not Working Well
1) Land or place the quadcopter on a level surface for 3-5 seconds without throttle (0% power).
2) Pair the drone with the transmitter again.
3) Land the drone with the throttle stick in full down position for 3 seconds and then take off again.
Quadcopter is Shaking and Making Noise
Check that the motors, canopy, body, and propellers are all properly positioned. If everything is intact and
properly fastened, re-stabilize your gyro by placing your quadcopter on a flat surface for 3-5 seconds.
Inguity® Max Speed Won't Take Off
Have you recently changed your propellers? Check that they are in the correct positions.
When propellers rotate, the direction of air movement should be down.
www.ingeniousingenuity.com