Epson P-4000 User Manual page 18

Charging the battery
After installing the battery, charge the battery using
the AC adapter.
Note:
The battery status is always displayed at the top right corner
of the LCD.
: Indicates sufficient battery power.
: Indicates moderate battery power.
: Indicates low battery power.
: Indicates battery power is running out. P-4000 is shut down
automatically. Charge the battery using the AC adapter.
: Indicates the AC adapter is connected to P-4000.
1. Make sure that the battery is installed.
Caution:
c
Do not connect the AC adapter when the battery is
not installed. Doing so may cause P-4000 to be
damaged.
18
Getting Started
2. Connect the AC adapter to P-4000 as shown below
and plug the other end into a power outlet.
The Charge lamp is on during charging. When the
battery is fully charged, the Charge lamp turns off. It
takes about 3 hours to fully charge the battery when
P-4000 is off. It takes more when you are operating it.
Note:
P-4000 stops charging, if the battery becomes hot when
operating it during charging. In that case, it starts charging
again when it cools down.