Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for ClearWater CWC-9
- Page 1 Installation Manual CWC-9 and CWC-9B (2006-2008 MX-5 / Miata Sound Systems)
- Page 2 • The system was designed so that anyone can install it with minimal tools. • As with all Clearwater purchases your satisfaction is guaranteed!! We are passionate about our audio and you should be too! Parts Included: Tools Needed: 1.
- Page 3 Step 2: Factory Speaker Removal • With the door handle held in the “open-the- door” position, gently insert a small flat head screwdriver behind the blank plastic insert and apply enough prying force to loosen. • With the door handle still in the “open-the-door”...
- Page 4 Step 2: Factory Speaker Removal • Remove the screw at the top of the grab handle with your #2 Phillips head screwdriver. • Locate the screw inside the doors cup holder and remove with your #2 Phillips head screwdriver. • Using your hands, start at the bottom of the door panel and pull outward to release the snaps from the back side of the panel.
- Page 5 Step 2: Factory Speaker Removal • Press the door handle from the back to “pop” it off of the door panel. Twist the door handle assembly so it can pass through the hole in the door panel. • Remove the connector from the door lock wires on the back side of the door panel.
- Page 6 This is easily done by grabbing the plastic with pliers and twisting them off. • Note that your factory speaker is oval and the CWC-9 replacement speaker is round. Following are instructions on putting this round peg in the oval hole.
- Page 7 Step 3: Clearwater Speaker Installation • There is a “groove” around the top and bot- tom of the oval opening that the factory put in place for us to easily be able to install the round CWC-9 speakers. Using the corner of your small...
- Page 8 Step 3: Clearwater Speaker Installation Custom Sound Module: • Inside the door cavity there is a side impact protection bar. Using the provided large zip tie secure the “Custom Sound Module” to the bar using the following directions: a) Feed the zip tie through one of the holes on the sound module.
- Page 9 Door Speaker: • Plug the wires coming from the sound module labeled “woofer” into the rear of the Clearwater door speaker. The red wire connects to the “red” terminal, the black wire connects to the “black” terminal, the white wire connects to the “white” terminal, and the green wire connects to the “green”...
- Page 10 Step 3: Clearwater Speaker Installation • Insert one of the supplied screws through the frame and the top hole of the water shield. • Insert the door speaker and water-shield into the door and loosely secure the top screw into place. Make sure that the wires do not get pinched between the woofer and door.
-
Page 11: Product Specifications
Woofers: Cone Material: Treated Paper Surround Material: Waterproof acoustic damped UV treated foam Power Handling: 200 Watts Nominal Impedance: 1 Ω (CWC-9B), 4.0 Ω (CWC-9) Weight: 2.25 lbs. each. Mounting Depth: 2.50” w/ Water shield Tweeters: Power Handling: 150 Watts Weight: 0.22 lbs. - Page 12 P.O. Box 428, Folsom, CA, 95630. Sincerely, Glenn and the team at Clearwater. The Clearwater Company | 2546 Mercantile Dr. Ste B | Rancho Cordova, CA 95742 Phone: (916) 852-7029 | Fax: (916) 852-9410 | www.clearwateraudio.com Version 6.0 | 7/20/12...
Need help?
Do you have a question about the CWC-9 and is the answer not in the manual?
Questions and answers