Floppy Drive Connector (Cn9); Atx Feature Connector (Cn10); Figure 2-4: Atx Adaptor Cable - SBC PCI-6771series User Manual

2.20 Floppy Drive Connector (CN9)

You can attach up to two floppy disk drives to the PCI-6771's on-
board controller. You can use any combination of 5.25" (360 KB/
1.2 MB) and/or 3.5" (720 KB/1.44/2.88 MB) drives.
The card comes with a 34-pin daisy-chain drive connector cable.
On one end of the cable is a 34-pin flat-cable connector. On the
other end are two sets of floppy disk drive connectors. Each set
consists of a 34-pin flat-cable connector (usually used for 3.5"
drives) and a printed-circuit-board connector (usually used for
5.25" drives). You can use only one connector in each set. The set
on the end (after the twist in the cable) connects to the A: floppy.
The set in the middle connects to the B: floppy.

2.21 ATX Feature Connector (CN10)

When the PCI-6771 is used as a stand alone card, both the 4-pin
main power connector (CN23) and the ATX feature connector
(CN10) must be connected to the power supply. If the PCI-6771 is
used with a passive backplane, the main power connector (CN23)
should not be connected as the card will be powered from the
backplane.
(P8) 6-pin in
backplane
(P9) 6-pin in
backplane
The ATX adapter cable (provided) is used to connect the PCI-
6771 to the ATX power supply. The ATX adapter cable has
To ATX feature
connector (CN10)
•
P 8 P 8
•
P 9 P 9
•
20-pin female connector

Figure 2-4: ATX Adaptor cable

ATX power supply
source
•
•
Chapter 2 Installation 23