Advertisement
VOLUME CONTROL BYPASS FEATURE
VOLUME CONTROL BYPASS FEATURE
*The sonaDAC includes a volume control bypass feature that removes the built-in volume
control from the signal path. When an input is selected it will light blue if volume control
*The sonaDAC includes a volume control bypass feature that removes the built-in volume
bypass is Off (the built-in volume control is in the signal path) or green if volume control
control from the signal path. When an input is selected it will light blue if volume control
bypass is On (the volume control in the source device must be used). To set this up:
bypass is Off (the built-in volume control is in the signal path) or green if volume control
bypass is On (the volume control in the source device must be used). To set this up:
Put the unit into Standby mode (the
B
Put the unit into Standby mode (the
B
Press and hold the PHASE button, then press and hold the
C
to enter the volume control bypass mode (all of the input buttons should now be lit).
Press and hold the PHASE button, then press and hold the
C
to enter the volume control bypass mode (all of the input buttons should now be lit).
Press the desired input button to toggle between volume control bypass On (the input
D
button LED lit green) and the volume control bypass Off (the input button LED lit blue).
Press the desired input button to toggle between volume control bypass On (the input
D
Off is the factory default setting for all inputs but any input or combination of inputs can
button LED lit green) and the volume control bypass Off (the input button LED lit blue).
be set to bypass the built-in volume control.
Off is the factory default setting for all inputs but any input or combination of inputs can
be set to bypass the built-in volume control.
Button to save the current settings and exit the volume control bypass
Press the
E
selection mode.
Button to save the current settings and exit the volume control bypass
Press the
E
selection mode.
Caution: When the sonaDAC is in volume control bypass mode, the source device is in
complete control of the output level sent to the power amplifier and speakers. If extra care
Caution: When the sonaDAC is in volume control bypass mode, the source device is in
is not taken, significant damage to your speakers or power amplifier can occur. Peachtree
complete control of the output level sent to the power amplifier and speakers. If extra care
Audio does not accept any responsibility for any damage caused by improper use of this
is not taken, significant damage to your speakers or power amplifier can occur. Peachtree
feature.
Audio does not accept any responsibility for any damage caused by improper use of this
feature.
USB
OPT1
OPT2
USB
OPT1
OPT2
Button will be lit red).
Button will be lit red).
COAX1
COAX2
COAX1
COAX2
7
7
Button for ~2 seconds
Button for ~2 seconds
PHASE
PHASE
Advertisement
