Figure 6-18: Site Survey - Linksys WAP54GP User Manual

Wireless-G Access Point with Power Over Ethernet
Wireless Bridge
This mode connects multiple physically separated wired networks with access points.
If you are trying to create a wireless connection between two wired networks, select Wireless Bridge and enter
the MAC addresses of the remote wireless bridge/access point in the MAC 1 fields. If you do not know the remote
wireless bridge/access point's MAC address, click the Site Survey button. Select the wireless bridge/access
point you want to use and click the Apply button. Then click the Close button to return to the AP Mode screen. If
you do not see the wireless bridge/access point you want, click the Refresh button to run another site survey.
The remote wireless bridge/access point also need to be set to Wireless Bridge mode.
If you are trying to create a wireless connection among multiple wired networks, select one Access Point as the
hub for point-to-multipoint connection. Enter the MAC address of the remote wireless bridges/access points in
the MAC 1-4 fields. The remote wireless bridges/access points will have the Hub's MAC address only in their
configuration.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click
More for additional details.
IMPORTANT: In Wireless Bridge mode, the Access Point can ONLY be accessed by
another access point in Wireless Bridge mode. In order for your other wireless devices
to access the Access Point, you must reset it to Access Point mode. The two modes are
mutually exclusive.
Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet
The AP Mode Tab

Figure 6-18: Site Survey

27