Advertisement
Turn the knob (master key) counter-clockwise to close the door.
•
3 continuous wrong entries will activate a 20 second warning beep
•
sequence.
: The keypad will be disabled during this beeping sequence. You can
only stop the beeps by opening the safe with the emergency key and removing
the batteries to cut the power.
1. With the door open, press the reset button once. The reset button can be
found on the inner hinge side of the door.
2. Once the reset button is pressed, the yellow light will go on. At this point,
start inputting your desired code.
3. Input your new code (3-8 digits), then press either 'A' or 'B' to confirm.
There will then be 2 buzzer sounds, indicating that the code has been
accepted and stored in the memory.
4. If the yellow light flashes with 3 buzzer beeps, this means that the code
changing has not been effective and you will need to try the sequence
again.
Upon the events of first receipt of the safe, an electronic malfunction or
unknown codes, the emergency key can be used to open the safe.
Remove the cover of the emergency lock.
•
Insert the emergency key, turn it counter-clockwise and then turn the
•
knob (master key) clockwise to open the door.
3
Advertisement
