Advertisement
Upon first opening, the user should open the safe with the emergency key. The
operation to do this in detail is covered in the section 'opening the safe with the
emergency key'.
Remove the emergency lock cover, then insert the emergency key and
•
turn it counter-clockwise.
Turn the knob (master key) clockwise, to open the door.
•
: When the operation has been finished, please remove the emergency
key and store it somewhere safe and private.
Open the door.
•
Insert 4 x AA batteries into the battery compartment.
•
Under normal conditions, if both the red and the green lights are on at the
•
same time, it means the voltage is low and you should insert new
batteries.
: Replace 4 fresh batteries by lining them up in a manner as indicated
by the + and – symbols. When outage is for longer than 30 minutes, you should
reset the user's code.
Input your user's code (3 to 8 digits), each press resulting in a buzzer
•
beep and yellow light flashes.
Press either the 'A' or 'B' button, and the green light will be on.
•
Rotate the knob (master key) clockwise and pull outwards within 5
•
seconds and the door will open.
: The preset user code is '159'. Please input this code again if the
yellow light flashes, followed by three buzzer beeps.
2
Advertisement
