Advertisement
1 sec. Once the doors have unlocked the parking lights will flash twice to
confirm that the doors are unlocked. (Also disarming your starter kill.)
To LOCK your doors, press Button 1 on your remote. When the doors
have locked, the parking lights will flash once. (Arming the starter kill.)
REMOTE TRUNK RELEASE OR GARAGE DOOR
REMOTE TRUNK RELEASE OR GARAGE DOOR
REMOTE TRUNK RELEASE OR GARAGE DOOR
REMOTE TRUNK RELEASE OR GARAGE DOOR
CONTROL
CONTROL
CONTROL
CONTROL
The Autostart has the ability to control the trunk release or an external
garage door opener system. (Option). If your Autostart was installed with
the power trunk release option, you can pop your trunk with button 1 & II
of the remote transmitter.
If your Autostart was installed with the garage door option, the garage
door can be opened by simply pressing on button I & II when in front of
the garage door.
STARTER KILL OPTION
STARTER KILL OPTION
STARTER KILL OPTION
STARTER KILL OPTION
If your Autostart was installed with the starter kill option, you will not be
able to start your vehicle with the keys unless the system has been
disarmed first. This option works with the door lock sequence. If you did
not get the door locks installed, ignore the reference to the door locks
operation below.
To disarm the starter kill system, press and hold Button 1 to unlock the
doors. When the system has been disarmed, you will get two quick flashes
through the parking lights.
NOTE: Locking the doors will rearm the starter kill unit.
Once the system has been disarmed, you will have approximately 45
seconds to insert the key in the ignition, turn it to the on position and start
the engine.
Once the engine has been turned off, the system will
rearm in 45 sec.
IDLE MODE OPTION
IDLE MODE OPTION
IDLE MODE OPTION
IDLE MODE OPTION
The Idle Mode Option can be enabled by your installer so that you can
leave the vehicle unattended and the engine running for the engine run
time. This is handy when you need to make a short stop or delivery
without having to stop the engine and restart it. If your stop is longer then
the engine run time, the engine will shut off automatically like on a remote
start.
If Idle Mode was enabled at installation, you can activate Idle Mode by
completing the following steps:
1.
Ensure that the engine is running.
2.
Hold button 2 for at least 3 sec. Parking lights will flash and stay on.
3.
Remove key from ignition.
4.
Exit the vehicle and lock the doors.
SAFETY FEATURES
SAFETY FEATURES
SAFETY FEATURES
SAFETY FEATURES
Autostart is equipped with a valet switch (ON/OFF) make sure that all users of the
vehicle know the location of the switch.
You should turn the switch OFF when:
•
Servicing Vehicle
•
Parking indoors (garage)
•
If there are problems with the remote starter.
When the switch is turned on, the parking light will flash twice to confirm that the
car-starter is in operation. Autostart is equipped with a pin switch in the engine
compartment. When the hood is raised, the 1200 is disabled. A faulty pin switch
can disable the remote starter. Make sure the pin switch is in good working
condition for reliable starts.
COLD WETHEAR STARTS
COLD WETHEAR STARTS
COLD WETHEAR STARTS
COLD WETHEAR STARTS
The Autostart has a feature that allows your vehicle to start every two hours for 5
minutes. This helps keep the engine warm during cold weather and makes starting
easier.
To place the Autostart into cold weather mode, press and hold button 2 for about 5
sec.
Note: that if Child Proof Operation was enabled, then Button 1 + 2 will have to be
pressed in order to activate cold weather mode. When the unit has gone into Cold
Weather Mode the parking lights will flash 3 times quickly.
You can cancel cold weather mode by doing the following:
•
Turn ignition key to the on position.
•
Start the vehicle by remote.
•
Open the hood.
The unit will automatically cancel Cold Weather Mode after starting the engine 12
times.
CHILD PROOF OPTION
CHILD PROOF OPTION
CHILD PROOF OPTION
CHILD PROOF OPTION
The child proof option can be enabled by your installer so that you must press and
hold button 2 for about 5 sec. In order to star the vehicle.
The Child Proof Option can be another security feature that you can use if you are
concerned by the possibility of starting your car without wanting it by briefly
pressing Button 2.
IGNITION LOCK
IGNITION LOCK
IGNITION LOCK
IGNITION LOCK
This feature can be turned on by programming the Autostart. If this feature has
been activated, the Autostart
Advertisement
