Nordic Start NS-1000 SH User Manual

Will automatically lock the doors when the key is turned to the on position
and the brakes are pressed.
When the ignition key is turned to the off position, the doors will
automatically unlock.
PROGRAMMING OPTIONS PROGRAMMING OPTIONS PROGRAMMING OPTIONS PROGRAMMING OPTIONS
The following can be programmed by your dealer:
•
Engine run time: 5, 15 or 25 minutes.
•
Number of retries: 2, 3 or 4 times
•
Maximum crank time: 6, 8 or 12 seconds
•
Child proof feature
•
Trunk release or Garage door control.
•
Idle mode feature.
DIAGNOSING PROBLEMS DIAGNOSING PROBLEMS
DIAGNOSING PROBLEMS DIAGNOSING PROBLEMS
Poor transmitting range
There are many factors which affect operating range. Some of these are:
•
Battery condition
•
Operating environment (Downtown RF noise)
•
Metal: any type of metal will affect operating range. Range in a
crowded parking lot will be significantly lower than open space.
•
Transmitter orientation: always hold the transmitter high;
approximately shoulder height. Holding the transmitter under the chin
will improve performance. Try it!
Engine does not start
If the engine does not start, check the following:
•
Is the transmitter LED working? If not, check the battery .
•
Are you pressing the transmitter long enough? Press the transmitter
until the parking lights activate.
•
Check the valet switch. When the power is turned ON, the parking
lights will flash twice to confirm power up.
VALET MODE VALET MODE VALET MODE VALET MODE
Autostart is equipped with a valet switch (ON/OFF) make sure that all
users of the vehicle know the location of the switch.
* To put the unit into Valet mode, simply turn the under dash switch to
OFF (system should now be in valet)
NS-1000 SH NS-1000 SH
NS-1000 SH NS-1000 SH
BASIC REMOTE OPERATIONS BASIC REMOTE OPERATIONS BASIC REMOTE OPERATIONS BASIC REMOTE OPERATIONS
The remote control unit has two buttons. Button 1, is used for remote keyless entry.
Button 2, serves to start the vehicle. Button I & II, Is for the convenience of
remote trunk release.
To start the car by remote, you must ensure that the hood is closed and that the
Valet switch is in the ON position. Press button 2, for about 1 second (or 4 to 5 if
the Child Proof feature was enabled by your installer). Once the button has been
pressed the parking light will come on to inform you that the unit has received your
signal, and has begun the start process. The car should be running after about 5 sec.
The vehicles parking lights will stay on the entire pre-programmed run cycle.
NOTE: Do not continue to press the remote once the parking lights activate.
Pressing the remote continuously for 4 seconds will activate "Cold Weather Mode"
and will Not start the engine.
If the vehicle doesn't start, the Autostart will shut off, wait a few seconds, then re-
try to start the engine again. The Autostart will try to start the engine a total of 2,3
or 4 times (programmable) before giving up.
With the vehicle running under remote control, enter the vehicle. Insert the key
in the ignition and turn the key to the "ON" position. Do not turn the key to the
"START" position with the engine running, this will cause the starter motor to
reengage.
NOTE: Do not forget to leave the heather or air conditioner turned on before
leaving your vehicle. So that your vehicle can be "PRE-WARMED" or "PRE-
COOLED" by remote control.
REMOTE DOOR LOCKS REMOTE DOOR LOCKS
REMOTE DOOR LOCKS REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the convenience
of remote keyless entry.To UNLOCK you doors, press and hold button 1 for about
USER-GUIDE USER-GUIDE
USER-GUIDE USER-GUIDE