Great Dane Scamper Hydro GLKW1536S Operator's Manual page 16

NOTE: Total system capacity is approximately 4.7 L (5 qt) however
some oil will remain in the wheel motors and lines. Approximately
3.3 L (3.5 qt) is required to refill to a safe operating level.
10.Fill reservoir with approximately 3.3 L (3.5 qt) of oil.
11.Install filler cap on reservoir.
12.Start engine and run at 3/4 throttle position. Unlock the park brake and
cycle the control levers forward and rearward several times. Check for
leaks.
13.Stop engine. Check reservoir oil fluid level. Add oil as necessary.
Adjusting Transmission Neutral Position
1.Park machine safely. (See Parking Safely in the Safety section.)
CAUTION: Avoid injury! Machine must be safely supported
on jackstands before removing or installing wheels. Do not
use a hoist or floor jack to support the machine.
2.Raise drive wheels off the ground and securely support the machine and
block caster wheels.
3.Start and run the engine until it reaches normal operating temperature.
4.Observe wheel movement as control levers are moved back and forth.
The wheels should travel in the correct direction as the levers are moved.
5.Move control levers (A) to neutral position; the wheels should stop
rotating.
• If the wheels continue to rotate, adjust the neutral adjustment knob(s)
(B), located on left and right sides of the machine until wheel(s) stop
SERVICE TRANSMISSION
A
MX18525
B
MX18529
Service Transmission - 15
rotating.
6.Shut engine off.
7.Lower the machine to the ground.
Adjusting Transmission Tracking
CAUTION: Avoid injury! Clear area of all bystanders before
performing this service procedure.
1.Park machine safely. (See Parking Safely in the Safety section.)
2.Start and run engine until it reaches normal operating temperature.
3.Move machine to an open area for operation.
4.Mark position of safety bar on side of bracket.
CAUTION: Avoid injury! Do not operate machine at a high
speed when checking for tracking. Adjust safety bar to limit
forward speed.
5.Loosen lever (A). Move safety bar (B) back away from the control panel
and tighten lever (A).
6.Drive machine forward, pushing both control levers all the way to safety
bar.
7.Check machine tracking.
• If machine does not drive in straight line, adjust control rod swivel (B)
located on both sides of the machine to compensate.
8.Adjust safety bar back to original operating position.
B
A
B
MX18525
MX18521