Service Engine - Great Dane Scamper Hydro GLKW1536S Operator's Manual

Use a general all-purpose grease with an NLGI grade No.2 rating.
Wet or high speed conditions may require use of a special-use grease.
Contact your Servicing dealer for information.
Spray Lubricant
Use a general-purpose petroleum-based spray lubricant.
Lubrication Points
B
A
• Grease caster wheel bearings (A).
• Grease caster wheel pivot bushings (B).
• Apply grease to three spindle bearings (C), until grease is expelled from
vent on spindle housings.

SERVICE ENGINE

B
A
MX18571
C
MX15287
Service Engine - 12
NOTE: Use spray lubricant to lubricate the following items:
E
• Spray lubricate speed control levers pivot shaft (D).
• Spray lubricate throttle control cable (E).
• Spray lubricate choke control cable if independent.
• Spray lubricate hydro pump lower control linkages (F) on both sides.
Service Engine
Avoid Fumes
CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.
Move the machine to an outside area before running the
engine.
Do not run an engine in an enclosed area without adequate
ventilation.
•Connect a pipe extension to the engine exhaust pipe to
direct the exhaust fumes out of the area.
•Allow fresh outside air into the work area to clear the
exhaust fumes out.
Engine Oil
Use oil viscosity based on the expected air temperature range during the
period between oil changes.
Use oil that meets the following specification:
• See the engine manufacturer's owner's manual provided with your
machine for the correct specifications.
Checking Engine Oil Level
IMPORTANT: Avoid damage! Failure to check the oil level
regularly could lead to serious engine problems if oil level is low:
• Check oil level before operating.
• Check oil level when the engine is cold and not running.
• Keep level between the FULL and the ADD marks.
• Shut off engine before adding oil.
NOTE: Check oil twice a day if the engine runs over four hours in a
day.
F
D
MX18565