Advertisement
WARNING
Do not place stickers, weight, or anything else on the helicopter. This may cause the helicopter to crash or malfunction.
Avoid flying the unit under low ceilings. Crashing into ceilings may cause damage to the helicopter.
To avoid injury, do not touch the blades or any other moving parts.
When not in use (especially for 30 days or more) remove 'AA' batteries from remote control unit -
batteries may leak and cause damage.
ENVIRONMENT FOR FLIGHT
Recommended flying area for indoor: 12'L x 12'W x 12'H (3.65 m L x 3.65 m W x 3.65 m H)
Avoid drafts, forced air, water, fans, heat and air conditioning vents.
Keep flying helicopters away from pets, young children, the elderly and the disabled.
USE GOOD COMON SENSE WHEN FLYING!
PARTS LIST:
1 Head cover
#
6 Balance bar
#
11 Tail support bar
#
16 Front motor
#
21
#
Photo / Video
download USB wire
4
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P: (586) 757-1336 E: Service@extremercbyrsi.com
SAFETY INSTRUCTIONS
ALSO AVAILABLE AT WWW.EXTREMERCBYRSI.COM
2 Main blades
#
#
7
Tailpipe with motor,
#
fin and tail
12 Blade connectors
#
#
17 Rear motors
#
#
22 Remote control
#
3 Tail blade
4
#
8
9 Li-poly battery
Main inner shaft
#
#
with motor gears
13
14
Center outer shaft
#
support cover
18
19
Bottom outer shaft
#
with blade connector
PARTS - SERVICE - REPAIRS
Toll Free: 888-221-8851 Tel: 586-757-1136 x 1
E-mail: Service@extremercbyrsi.com
Website: www.extremercbyrsi.com
OPEN: Mon - Fri 9 AM to 6 PM ... Sat 10 AM to 3 PM (EST)
5 Landing gear
#
Fuselage housing with
bottom outer shaft
10
#
15 Top blade connector
Top shaft center
#
head cover
20 Camera / video
Circuit board with
#
ON / OFF switch
Side support metal
plates
Advertisement
