Advertisement
RELEASE SAFTY
A safty is built into the remote control. To release the safty
move the left throttle up down. Safety has been released.
YOU ARE NOW READY TO START FLYING!!
Hover up and down
Learn how to hover (fly in place) first - once you've mastered
this operation, flying is easy. Once you can hover, try moving
up and down with the throttle stick (left). Move the throttle
stick gradually.
SS1-CV
INFRARED
REMOTE
Forward
Push the right control throttle up - the nose of the helicopter
will point downward, the tail motor will activate, and the
helicopter will fly froward.
Note: Calibration trim control ... if the helicopter is turning excessively to the right or left,
or turning out of control, adjust the trim control knob using the instructions below.
If helicopter rotates counter-clockwise ... turn calibration control knob right until excessive turning stops.
If helicopter rotates clockwise ... turn calibration control knob left until excessive turning stops.
Distributed and serviced by: Extreme RC by RSI, Ferndale, MI 48220 P: (586) 757-1336 E: Service@extremercbyrsi.com
CAMERA / VIDEO
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
UP
DOWN
MIDDLE POSITION
SAFTY IS OFF
Turn counter clockwise and clockwise
While hovering helicopter, push throttle stick left for
counter-clockwise turns or right for clockwise turns.
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
Pull right control throttle down - the nose of the helicopter
will point upward, the tail motor will activate, and the
helicopter will fly backward.
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
Reverse
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
Calibration control knob
SS1-CV
CAMERA / VIDEO
Calibration control knob
SS1-CV
CAMERA / VIDEO
SS1-CV
CAMERA / VIDEO
INFRARED
REMOTE
3
Advertisement
