Maintenance; Fcc Statement - HoMedics SP-105H-TP Instruction Manual

• This product should NEVER be used by any individual suffering from
any physical ailment that would limit the user's capacity to operate the
controls or who has sensory deficiencies.
Caution: • This product is not for use in automobiles.
• Household use only.
To avoid pinching
• Attention California Residents:
do not lean on
WARNING: This product contains chemicals known to the
State of California to cause cancer, birth defects and other
Shiatsu massage
reproductive harm.
mechanism in
Instructions for Use
the pillow when
adjusting your
To reduce the risk of electric shock, this appliance is equipped with a
body position.
polarized plug (one blade wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. It it still does not fit, contact a qualified electrician to
Do not jam or
install the proper outlet. Do not change the plug in any way.
force any part of
Insert the power cord into a 120 volt AC outlet. To activate the Shiatsu
your body in the
massage action, press power button once (Figure 1). To activate the
moving massage
vibration massage, press the power button a second time. To activate
mechanism. Shiatsu and Vibration massage together, press the power button a
third time. To activate soothing heat with the massage, press the heat
button. Massage heads will glow red (Figure 2). Allow a few moments
for the heating action to warm up. To activate massage intensity press
H/L button once for low, press once more for high. When finished
press the power button again to turn off the massage and heat
function and unplug the pillow.
The 3D Shiatsu and Vibration Pillow is very versatile and designed for
use on the neck, back and shoulders (see Figures 3 and 4). However,
you may find it works well for other body areas as well.
The massage cushion incorporates a unique strapping system which
allows you to fasten it to almost any chair. Just slip the straps over the
seat or chair and adjust fastening straps to secure. Your massager
won't slip or slide away.
NOTE: For the neck and shoulders it may work better to use the
pillow upside down as shown in Figure 5.
IB-SP105H.indd 5-6
4
NOTE: Only gentle
force should be
exerted against
the unit in order
to eliminate any/
Figure 1 Figure 2
all risk of injury.

Maintenance

To Store
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed
objects which might cut or puncture the fabric surface. To avoid breakage, do not wrap the power
cord around the unit. Do not hang the unit by the power cord.
To Clean
Unplug the unit and allow it to cool before cleaning. Spot clean only with a soft, slightly damp
sponge. Never allow water or any other liquids to come into contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass / furniture polish or paint
thinner to clean.
• Do not attempt to repair the Shiatsu Massage Pillow. There are no user serviceable parts.
For service, call the Consumer Relations telephone number listed in the warranty section.

FCC Statement

Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: HoMedics is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Figure 3 Figure 4 Figure 5
5
5/22/15 12:20 PM