Assembly Search Coil Control Pod Camlock Non-metallic Washers Display Camlock Control Buttons Velcro Amrstrap Fiber Rod Search Coil Center Rod Connector Fiber Bolt & Search Coil Thumbnut Cable Handgrip Battery Holder with Cap Grip the detector and sweep the search coil over the floor. If the fit feels uncom- Remove all parts from the shipping carton and check assembly diagram to ensure fortable, adjust the position of the lower fiber rod.
1. Press the power ON button. Upon initial power up, the detec- light. Holding the power button while on will turn the MX Sport off. tor defaults to the Coin and Jewelry program.
The following is a list of options available in the MX Sport. the MX Sport enters Options mode. As mentioned above, Options mode will only affect the display. The MX Sport will still provide au- dio feedback from the target system. The MX Sport will automati- cally leave Options mode approximately 10-15 seconds after the last time any button is pressed on the keypad.
Adjustments made to options in the menu are saved each time the user changes programs and each time the MX Sport is turned off. Per- forming a factory reset as detailed following will return all Programs to...
Page 7
+ & - buttons adjusts the sensitivity, or responsiveness, of will exit options. the MX Sport. If the sensitivity is set too high, excessive noise will make it difficult to locate targets due to the noise from either Options will be slightly different depending on the search pro- the ground or external electric interference.
Locking the Tracking POWER prior to searching locks the ground balance at the ferrite A quick press of the button turns the MX Sport ON. Another (high iron) level. quick press of the power button toggles the backlight on and off.
Beach: The Beach program has features built in to ignore con- Display & Controls, cont. ductive wet or salty soils. Use Beach anytime you are searching Boost feature, which amplifies the audio responses of small a salt-water beach. And because many fertilizers are conduc- signals.
Discrimination When a metal target doesn’t indicate as expected, peculiarities Each of the MX Sport programs begins with Discrimination set- within that metal’s alloy mix (metal types) are usually to blame. tings pre-selected for most hunting. As alloyed steel bottle caps age, the iron deteriorates and the better (non-iron) alloys remain and become prominent (e.g., very...
Threshold 3. Press Options to exit or wait 10–15 seconds for the options The MX Sport can be used in silent search (no sound until a mode to automatically time out. target is detected), or with a Threshold (steady continuous back-...
Backlight ground balance range added to a program other than Beach The MX Sport has a backlit display option for use in low-light include Relic or Prospecting programs Thus, the salt option is conditions. Backlight use will reduce battery life (slightly, 10% to available in the Options mode and can be added or subtracted 20%) but may be necessary in some conditions.
Because these spots have a sharp increase in the changing threshold hum, they are not significant enough conductivity, the MX Sport will likely beep regardless of whether to dictate any operator change in settings. SAT automatically metal is present. If a reasonable beep is produced that doesn’t...
Care must always be used to leave the area as you found it or better. Fundamental to detecting success is choosing great places to use your MX Sport. These can be researched by word of mouth, at the library, in the newspaper, in FCC Compliance books, or on the Internet.
Service In the unlikely event that you have trouble with your White’s metal detector that your retailer can not satisfactory help you with, White’s has warranty service centers in the USA, and most re- gions outside the USA. For our service centers nearest you, please see our website: www.whiteselectronics.com Warranty If within two years (24 months) from the original date of purchase, your...