Reversing The Doors - Blomberg KGM 9691 Operating Instructions Manual

Reversing The Doors

We recommend that you reverse
doors before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted hinge
operation are supplied in a plastic bag
with the appliance:
- Upper door top trim hinge covers –
there are 2 different parts, one for each
side of top trim.
- Upper door middle hinge bushing/
door stopper assembly.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing doors, in a safe place for
possible future, re-use.
Important:
We suggest you ask somebody to help
you when moving the appliance around
and to hold doors when removing / re-
fitting hinges and doors to avoid any
injury and damage to the product.
Please refer to diagrams supplied. To
follow numbers in brackets below, refer
to the main diagram.
1. Switch off the appliance at the socket
outlet and pull out the mains plug.
2. Remove all loose items and fittings
and food, if any, from inside the
appliance and door racks.
3. Gently prise off plastic hinge covers
on both sides of upper door top trim
and front top panel using a small
flat-headed screwdriver. (1)
4. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this. Once you tilt
the appliance back, check to make
sure the appliance is completely
stable and safe before you carry on.
(2)
5. Unscrew and remove the lower hinge
using a cross-headed screwdriver
while holding the lower door firmly. (3)
6. Remove lower door carefully off the
middle hinge and stand door upright
in a safe place. (4)
7. Open upper door and unscrew
and remove the middle hinge while
holding the upper door firmly. Use a
flat-headed screwdriver. Middle hinge
will need to be rotated 180 degrees
before re-fitting on the opposite side.
(5)
8. Remove upper door carefully off the
upper hinge and stand door upright
in a safe place.(6)
9. Unscrew and remove the upper hinge
using a flat-headed screwdriver.(7)
14
EN