Philio PST02-A Manual

Slim Multisensor PST02-A/B/C
The slim multisensor PST02 has PIR, door/window, temperature and
illumination, 4 sensors function in one, based on Z-Wave
It is the Z-Wave TM plus product, it support the security, OTA... Those
newest features of the Z-Wave
communication protocol designed for home automation, specifically to
remotely control applications in residential and light commercial
environments. The technology uses a low-power RF radio embedded or
retrofitted into home electronics devices and systems, such as lighting,
home access control, entertainment systems and household appliances.
This product can be included and operated in any Z-Wave
with other Z-Wave TM certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
TM
TM technology. Z-Wave TM is a wireless
TM 500 series chip, when your Z-Wave
TM 500 series devices. The
Concurrent multi-channel support reduces external interference.
•
Better RF range, improve about 10 meters in indoor.
•
Support 100 Kbps transmit speed, speed up communication.
•
Function Compare A/B/C
PST02-A
PST02-B
PST02-C
Add to/Remove from Z-Wave
There are two tamper keys in the device, one is in the back side,
technology.
another is in the front side. Both of them can add, remove, reset or
association from Z-Wave
In the first time, add the device into the Z-Wave
sure the primary controller is in the add mode. And then power on the
device, just take out the insulation Mylar in the back side of the device.
The device will auto start the NWI (Network Wide Inclusion) mode. And
it should be included in 5 seconds. You will see the LED light ON one
second.
TM network
TM
1
PIR Temperature Illumination
Door/Window
V V
V
V
TM Network
TM network.
TM
V V
V V
V V
network. First, make