Advertisement
GETTING STARTED WITH THE TH60
Thank you for purchasing the TH60 Throat Microphone. The TH60 is the first
throat microphone designed specifically with performers in mind. This section outlines
step-by-step instruction to quickly show you how to connect your TH60 system to a
sound system while introducing you to some of its features.
Belt-Pack Setup
1. Install 9-volt battery by removing
battery door on the back of the unit
and attaching battery to the battery-
clip. Replace battery door.
2. Plug 1/8" gold-plated connector of the
throat microphone into the small
connector on the belt-pack.
3. Plug output cable into 1/4" output
connector on the belt pack.
4. Turn unit on by sliding the two-
position slide switch up. (note: unit
will not power-up and lights will not
light unless 1/4" cable is connected to
belt-pack output).
Throat Microphone Setup
1. Hold collar up against your throat
(low) with the plastic capsules aligned on either side of your adam's apple
(sorry ladies: where your adam's apple would be if you were a man).
2. Secure the collar around your throat by hooking the collar in the back
3. The collar can be resized to fit your neck by sliding the plastic adjustment
guides in the back of the collar.
Now you know the basic setup for your new TH60 Throat Microphone. If any
problems occur, please refer to the Troubleshooting section of this manual. The rest of
the manual goes into greater detail on features and applications. Please read the rest of
the manual to help you make the most of your TH60.
~
WARNING!
switch/option called "Phantom Power." DO NOT turn on Phantom Power if the
TH60 is connected or you will damage the TH60 and possibly injure yourself.
Mixing boards and microphone pre-amplifiers feature a
Advertisement
