Air Filter; Exhaust Silencer; Lubrication Of Vehicle; Filling And Discharging Oil Screw - JAWA babetta 28 Servicing Instructions

Fig. 8 Air filter
The air filter element (fig. 8) is to be washed from
time to time in petrol. Clean from to time the hole B
of exhaust silencer (fig 9) from the carbon. When
bigger decrease of output check whether the
exhaust silencer is not choked by the carbon. The
exhaust end piece is able to be pulled out after
screwing out the nut A.
Fig. 9 Exhaust silencer
The oil in the gear box is to be changed after the
ride only, when the oil and the engine are warm.
Unscrew the discharge screw from the engine
Lubrication Table (fig. no. 10)
Fig. Lubrication point
1 Engine
2 Gear box
3 Steering
4 Gas twist grip
5 Brake and decom-
pressor levers
6 Bowdens
7 Wheel bearings
8 Brake cam pin, cams,
brake shoe pins
9 Chains
10 Stand pin
11 Pedal bearings
12 Front telescopic forks
13 Idling run wheel
Page 4
Lubricant kind
oil for two stroke
engines SAE 30 M2 T
gear oil
SAE 30-80 (PP 80)
bearing grease
(AV 2)
grease (AOO)
oil SAE 30
(M 6A)
thin oil
bearing grease (AV 2)
grease (A 00)
graphite oil,
grease (A 00)
oil SAE 30 (M 6A)
oil SAE 30 (M 6A)
oil SAE 30 (M 6A)
oil SAE 30 (M 6A)
Babetta type 28 owners handbook pages 20 to 24
bottom part (2, fig.11). After discharging the oil it is
suitable to wash the gear box by the rinse oil. Fill
the new gear oil through the filling hole 1 up to
control orifice 3. From time to time check the oil
level in the gear box and refill if required.
Fig. 11 Filling and discharging oil screw
1. Filling hole screw, 2. Discharge oil screw
3. Control hole
Fig. 10 Lubrication of vehicle
Notes
permanent lubrication,
Oil and petrol ratio 1:30
charge 0.02 galls, (0.13 lt)
wash and grease
when dismantling
apply on the sliding
parts after washing
fill in bowdens
refill in bearings
grease with small
quantity after cleaning
clean and grease as
required
www.jawamoped.com
jkw