Vehicle Control Elements; Riding Instructions; Filling The Fuel Tank; Starting The Cold Engine - JAWA babetta 28 Servicing Instructions

II.

VEHICLE CONTROL ELEMENTS

The moped is easy to operate and for its
servicing:
Are required the following elements only:
a) Throttle twist grip (1, fig. 2) the rotation of which
disengages and engages automatically the clutch
by releasing and throttling the gas and further this
is used to regulate the velocity of vehicle.
b) Front brake (2, fig. 2) and rear brake (3, fig. 2)
levers by means of which the moped is braked and
stopped
c) Decompressor lever (4, fig. 2) by means of
which the engine is stopped or the start is
facilitated.
d) Buzzer push-button (5, fig. 2)
e) Dip switch (fig. 3). The buzzer and the front and
rear lights may be in operation during the engine
function only.
f) Fuel tap (fig. 4)
g) Air closing push button (fig. 5)
h) Pedals (fig. 6)
i) Disengaging the engine (fig. 7)
Fig. 2. Steering of vehicle
1 Gas grip, 2. Front brake lever, 3. Rear brake
lever, 4. De-compressor lever, 5. Bell
Fig. 3. Switch of lights
(in the lower part of headlamp)
Fig, 4. Fuel tap 0-opened fuel supply, R-reserve
Page 2
Running-in new motorcycle
Thoroughly run-in new moped influences its
output, consumption and service life. Take into
consideration the following instructions when
running-in:
a) Drive mixture - M2T oil with 80 octanes petrol be
mixed in ratio 1:25,
b) This ratio keep during the running-in (500 km
abt.),with maximum opening half rotation of throttle
twist grip (speed abt. 20 km/hr.),
c) When longer drives we recommend to lubricate
the engine by opening he throttle. When riding
downhill we do not recommend to throttle the gas
but to use the rear brake.
d) When stopping let the engine run at idle speed
and ovoid to open the throttle uselessly.
III.
Check before the drive
- the correct function of brakes
- the inflation of tyres
- fuel level in the tank
- the function of buzzer and lights (during the
engine run)

Filling the fuel tank

As the fuel is used the petrol mixed with oil.
Maintain the specified ratio of oil and petrol, at the
fuel pump take this ratlo, is observed; Use as a
minimum 80-octanes petrol. The tank is to be filled
with the funnel provided with strainer.

Starting the cold engine

Open the fuel tap (fig. 4) press the push button of
air closure (fig. 5) up to contact (after depressing
the pin jumps out, the air, however remains shut)
There are two kinds of starting the engine. Starting
the cold engine during the summer period.
Fig. 5. Air closing push button
Babetta type 28 owners handbook pages 8 to 14
www.jawamoped.com

RIDING INSTRUCTIONS

jkw