Kenmore 153.329266 Use & Care Manual page 14

5.
6.
LIFT OUT TAB TO UNCLIP
TERMINAL COVER FROM
THERMOSTAT
TURN OFF
POWER
BEFORE
SERVING
COVER
TO REMOVE
PULL ARROW
AT TOP OF
FIGURE 16.
Remove the screws from terminal 2 of the element, and
move the looped end of the wire aside.
FIGURE 17.
The buss bar is labeled 5500 W. Place the buss bar over
terminals 2 and 3 with the 5500 W visible. Install the extra
screw provided into terminal 3.
IIIIIIIIIIIII
8. Tighten terminals 2 and 3 to ensure proper electrical
connection.
Fire and Explosion Hazard
" Failure to tighten screws can
cause a fire.
,, Failure to do this could result in
death, serious bodily injury, or
property damage.
Failure to tighten terminal screws can cause a fire which can
result in DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
9. Replace terminal cover on thermostat making sure that the
locking tabs on the terminal cover are in place.
place
Fire and Explosion Hazard
• Thermostat must be flush
against the tank.
• Make sure terminal cover is in
and the insulation
replaced.
• Failure to do this could result in
death, serious bodily injury, or
property damage.
Make sure the thermostat is flush against the tank, the terminal
cover is in place, and the insulation is replaced. Failure to
do so can result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
10. Replace the insulation so that it completely covers the
thermostat and elements.
7.
FIGURE 18.
The wire removed from terminal 2 has a looped end. It must
remain looped and now be placed (as shown) on top of the
buss bar, over the opening of terminal 2, and secured using
the remaining screw.
FIGURE 19.
14
FIGURE 20.