Advertisement
before leaving the manufacturing facility, your LeMond R
your LeMond R
should arrive packed in 1 carton. Upon arrival fully inspect the carton for damage. If damage is found please
evolution
contact the delivery company and the LeMond customer Service Department at (425) 482-6773 to report any damage.
Remove ALL components and parts from the packaging and check them against the list below and Figure 1.1.
The following items are included with your LeMond R
bike trainer:
•
Trainer body Assembly
•
Trainer base Assembly
•
one (1) long button head M8 by 60mm screw
•
Skewer Assembly
•
5mm Allen key for assembly
•
quick-Start guide
•
owner's Manual
Warning: ThE boDy ASSEMbLy WEIghS 28LbS (12.7 kg). USE cAUTIoN WhEN hANDLINg ThE boDy ASSEMbLy AND bE
!
SURE To SUppoRT ThE ASSEMbLy pRopERLy WhILE INSTALLINg ThE bASE ASSEMbLy. FAILURE To FoLLoW ThESE
INSTRUcTIoNS MAy RESULT IN pRopERTy DAMAgE oR INjURy.
Note: Ensure that you have all the parts listed and illustrated
above prior to beginning assembly.
1.
place the body assembly fan-side down on the edge of a
table with the belt wheel away from you and the black ship-
ping base overhanging the edge of the table. (Figure 1.2)
Note: The fan shroud should hang 1-2 inches over the table edge
to allow full installation of the base.
2.
Remove the shipping base and set two of the screws aside
for use in the next step. Discard the shipping base and the
remaining screw. (Figure 1.2)
3.
Install the base assembly to the body assembly using the
included 60mm screw and two 15mm screws removed from
the shipping base.
•
begin by starting the longer (60mm) screw through the
center arm of the base assembly into the body assem-
bly. Do not fully tighten to allow the other two screws to
thread in easily.
•
Next, install the two shorter (15mm) screws into the re-
cessed holes near the center foot.
•
Tighten all three screws.
4.
Insert the skewer into the body assembly from the fan side
and thread the acorn nut onto the skewer on the cassette
side. (Figure 1.3) Do not fully thread the acorn nut in place
to allow for bike mounting.
Note: Ensure the spacer is installed on the fan side of the unit and
that both springs are present on the skewer as shown in
Figure 1.3.
Note: Please consult the R
u
npackinG
evolution
a
SSembly
Owner's Manual if you have questions about your R
evolution
i
nStructionS
bike trainer was thoroughly inspected.
evolution
i
nStructionS
5.
place the entire unit on the floor where it will be used, and
adjust the leveling feet to ensure stability.
Note: Handle the unit only by lifting from the base assembly, NOT
the fan cover or the belt wheel.
Warning: IF ThE LEvELINg FEET ARE NoT SET pRopERLy
!
IT cAN RESULT IN AN UNSTAbLE bASE FoR ThE UNIT
AND LEAD To pRopERTy DAMAgE oR RIDER INjURy.
Trainer Body Assembly
Trainer Base Assembly
bike trainer.
evolution
Skewer Assembly
M8 x 60
5mm Hex Key
Figure 1.1
60mm
15 mm
Figure 1.2
Figure 1.3
Advertisement
