Advertisement
W ARNING
E lectrical S hock H az ard
P lug into a g rounded 3 prong outlet.
D o not remove g round prong .
D o not use an adapter.
D o not use an ex tension cord.
F ailure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Re q u ire d :
A 120 volt, 6 0 Hz , AC only, 15- or 20-amp electrical supply
I
with a fuse or circuit breaker.
The shadowed area of Template A represents the top of the
microwave oven. Make sure it is centered in the space where the
microwave oven will be installed.
A
A. Template A
B. Cabinet front edg e
In s ta lla tio n Un d e r Ca b in e t w ith o u t P a rtitio n
1. If the cabinet does not have a partition, place the template
(Template A) on the lower shelf of the cabinet, as shown in the
illustration at the beginning of this section.
2. Tape the template into place.
3. Proceed to "Mark and Drill Holes" section.
Ele c tric a l Re q u ire m e n ts
INSTALLATION INSTRUCTIONS
P la c e Ca b in e t Te m p la te
B
Re c o m m e n d e d :
A time-delay fuse or time-delay circuit breaker.
I
A separate circuit serving only this microwave oven.
I
GROUNDING INSTRUCTIONS
F o r a ll c o r d c o n n e c te d a p p lia n c e s :
I
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
W ARNING:
Improper use of the grounding plug can
result in a risk of electric shock. C onsult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt ex ists as to whether
the microwave oven is properly grounded.
D o not use an ex tension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
In s ta lla tio n Un d e r Ca b in e t w ith P a rtitio n
1. If the cabinet has a partition, or if the microwave oven is being
installed under adjoining cabinets, cut Template B from
Template A.
2. Cut Template A into two pieces to fit into each side of the
partition.
3. Align each piece of Template A so that it is flush with the front
edge of the cabinet, as shown.
A
B
A. Template A (in 2 pieces)
B. Template B
C. H ole centerlines
D . P artition
4 . Align the Hole Centerlines of Template A with those of
Template B , as shown.
5 . Tape the template pieces into place.
D
C
3
Advertisement
