Troubleshooting - SUNTEC Klimatronic Progress 7.0 plus Instruction Manual

Troubleshooting

Troubles
Unit does not start when pressing POWER
button
Not cool enough
Noisy
several operation icons will blink
E0 Code
E2 Code
Can I switch the PROGRESS unit on
immediately after unpacking it?
When switching on the PROGRESS unit I sense
a smell. What should I do?
Can I operate the PROGRESS unit WITHOUT
the extract air hose?
At which intervals should the activated carbon
filter of the PROGRESS unit be replaced?
Possible Causes
- Water full indicator lamp blinks, and water tank
is full.
- Room temperature is higher than the setting
temperature. (Electric heating mode)
- Room temperature is lower than the setting
temperature. (Cooling mode)
- The doors or windows are not closed.
- There are heat sources inside the room.
- Exhaust air hose is not connected or blocked.
- Temperature setting is too high.
- Air inlet is blocked.
- The ground is not level or not flat enough
- The sound comes from the flowing of the
refrigerant inside the air conditioner
- at a room temperature higher or equal 18°C, Auto mode and cooling mode will work together.
If the room temperature is equal to or above 18 ° C, the unit can cool in the automatic mode. At
lower temperatures the device will protect the compressor by automatically switching into ventilation
mode.
There is evidence that this error massage is
caused to a room temperature which is too high.
It can also caused by a temporary fault at the
rating between incoming-
temperature.
Water tank full
Production-related cause or incorrect storage of
unit at e.g. dusty areas.
Suggested Remedies
Dump the water out of the water tank.
Reset the temperature
Reset the temperature
Make sure all the windows and doors are
closed.
Remove the heat sources if possible
Connect or clean the exhaust air hose.
Reset the temperature
Clean the air inlet.
Place the unit on a flat, level ground if possible
It is normal.
Please turn off the unit and turn in on after 30
minutes. If this fault is everlasting, your
PROGRESS unit should be checked by a
and outcoming professional.
Please empty the water tank.
No.
The PROGRESS unit must be placed upright for
at least 24 hours after every transport.
Otherwise the compressor may be damaged
and there is no capacity.
Odour development can arise on first use and
after a longer period of non-use by storing in
unsuitable areas (e.g. dusty areas).
Run the unit for ½ a day. The smell will
disappear after a while. In the case of intensive
odour development, air the room.
Yes, but only in dehumidification mode.
To achieve temperature adjustments, surplus
coldness must be discharged.
To use the purpose of the filter fully, it should be
replaced every 6 months.
7