Prif Crescendo 1 User Manual page 6

You will need to install the amplifier next.
4. Take your amplifier and locate the two connectors.
Simultaneously push the connectors into the
headphone jack of the PS4 controller and
the port in the back of the PowerPak 1.
5. Switch the unit ON via the On/Off switch.
6. Utilise the volume wheel to boost the volume to
your satisfaction. You can mute your mic from the
Crescendo 1 itself instead of via your headset if you
prefer, or if your headset lacks a mute control.
Both the PowerPak 1 and Crescendo Amplifier must
be switched on for audio to pass through to your
headset. If the PowerPak 1 is on but the Crescendo 1
amplifier is switched off, no audio will be heard.
11
CAUTION!
•
Not suitable for children under 3 years of age. An adult
should supervise young children when using this product.
•
Do not store in areas of extreme low (0°C) or
high (40°C) temperatures. Avoid direct sunlight,
heat sources and extreme humidity.
•
Do not allow the product to get wet or
dirty; doing so may cause damage.
•
Do not clean any parts with alcohol, cleaning solutions
containing alcohol or strong abrasives.
•
Do not dispose of this product in fire or in normal household
waste. Please take it to an electrical waste collection point.
•
There are no user serviceable parts within this product. Do not
take the product apart; doing so will void your warranty and
may cause electrical shock or damage to internal components.
This product is covered by two [2] years warranty.
For full Terms and Conditions, and for Technical Assistance,
go to : www.prifgear.com/customersupport
Priferential Accessories Ltd hereby declares that this product is in
compliance with the essential requirements and other provisions
of Directive 2004/108/EC and R&TTe 1999/5/EC.
12