Prif Crescendo 1 User Manual page 5

Thanks for purchasing the Crescendo 1 ! We would like to
thank you for choosing this prif product and welcome you
to the prif family.
Please read this booklet thoroughly before using the product.
Please register this product NOW.
It's easy to do via your computer or phone. This way we
will know when you bought the product and if you need help
in the future will make life much easier for you and us.
Just go to www.prifgear.com/register
Also please Follow us @prifgear and
Like our Facebook Page www.facebook.com/prifgear
For help with the set-up or operation of this product,
please contact our customer support team via
social media or through our tech support page
www.prifgear.com/customersupport
9
SETUP
The Crescendo 1 comes in two parts:
i. The main amplifier unit (with volume and mute
controls), which plugs into the 3.5mm headphone
jack on the front edge of the PS4 controller.
ii. The PowerPak 1 which plugs into the Micro-USB slot on
the PS4 controller and fits underneath the controller.
You will need to install the PowerPak 1 first.
1. The PowerPak 1 will require charging before use.
Please give the PowerPak 1 a full 3-4 hour charge
utilising the micro-usb cable provided in the box.
2. Connect the PowerPak 1 to the PS4 controller by
plugging it into the Micro-USB slot on the rear of the
controller below the Sony logo and light panel.
3. The device won't provide power to the PS4 controller
until the power button is pressed, at which point a
small red LED will illuminate and the controller's light
panel will glow. Whilst plugged into the PS4 controller,
if the LED flashes red, it indicates the battery is low.
Please charge the PowerPak 1 immediately.
10