Table of Contents
Advertisement
2- Rear view
18
17
1
2
3
4
① MIDI OUT
This jack outputs midi PC# (program/patch change) and CC# (Control Change).
② DC IN
Power input, works with negative center
③ TUNER
This jack switches to BUF IN or NBUF IN when GEC8 is muted, normally it connects to a tuner.
④ BUF IN
Buffered input jack, signal via this jack is fed to a buffer circuit prior to being sent to the loops.
⑤ BUF OUT
The jack outputs buffered signal when guitar is connected to BUF IN.
⑥ NBUF IN
Non-buffered input jack.
⑦ LOOP1~4
S1~4 is "SEND" of loop1~4, R1~4 is "RETURN" of loop1~4, the four loops only support mono
guitar pedals, loop1 to loop4 are internally connected, the signal chain is
BUF IN (NBUF IN) -> loop1-> loop2->loop3->loop4
⑧ LOOP5
This is a mono "SEND" and stereo "RETURN" loop, S5 is "SEND", R5 R is "Right Return" ,
R5 L is "Left Return", loop5 is after loop4 and prior to OUT R and OUT L.
⑨ OUT R
Output RIGHT jack, connects to R5 R of loop5, OUT R can be shut off in Programming mode.
⑩ OUT L
Output LEFT jack, connects to R5 L of loop5, OUT L can be shut off in Programming mode.
⑪ FOOTSWITCH
This jack combine FS1,FS2, SEND6, SEND7, SEND8, could be used for amp swithcing.
With the FS6 cable (provided separately), this jack can be connected to the FS IN jack on the
SHADOW pedal, which allows user to configure the channel switching for different amplifiers.
16
15
5
6
DC 9V of which the capacity
14
13
7
3
12
8
9
10
should be above 350mA .
11
Hide quick links:
Advertisement
Table of Contents
