Chevrolet Trax 2016 Owner's Manual page 167

166 Infotainment System
Using the Digit Dial Command
The digit dial command allows a
phone number to be dialed by
entering the digits one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone.
If an unwanted number is
recognized by the system, say
Clear at any time to clear the last
number.
To hear all of the numbers
recognized by the system, say
Verify at any time.
g
1. Press / . The system
responds Ready, followed by
a tone.
2. Say Digit Dial.
3. Say each digit, one at a time,
that you want to dial. After
each digit is entered, the
system repeats back the digit it
heard followed by a tone. After
the last digit has been entered,
say Dial.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
g
1. Press / . The system
responds Ready, followed by
a tone.
2. After the tone, say Re-dial.
The system dials the last
number called from the
connected cell phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
g
Press / to answer the call.
i
Press / to ignore a call.
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
g
Press / to answer an
incoming call when another call
is active. The original call is
placed on hold.
g
Press / again to return to
the original call.
To ignore the incoming call, no
action is required.
i
Press / to disconnect the
current call and switch to the call
on hold.
Three-Way Calling (If
Equipped)
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press
2. Say Three-way call.
g
/ .