Cervelo S5 Supplementary Manual page 17

• Feed the rear derailleur cable across the bridge in the access
port, and into the rear opening of the cable guide port.
• Feed the cable along the drive-side chainstay until the cable
bottoms out against the end of the chainstay.
• Using a hooked spoke or other method of extraction, fish the
cable through the hole on the upper face of the chainstay.
• Thread the click-in cable stop onto the cable so that the retention
clip faces the rear of the bike.
• Insert the cable stop into the frame by hooking the forward
facing lip of the stop into the hole in the top tube and push
gently on trailing edge until a click is felt to secure it in place.
• Do not attach the cable to the rear derailleur at this time.
STEP 3: Single–Bend Cable Guide Installation
Now the S5 single-bend cable guide must be put in place to
ensure smooth and precise shifting.
• Lift the shift cables off of the cable port bridge, and slide the S5
plastic cable guide underneath them while ensuring that the
deeper cable track is oriented toward the drive-side.
• Locate the rear derailleur cable in the deeper drive side cable track.
• Locate the front derailleur cable in the remaining track ensuring
that the plastic cable guide tube does not cover cable in the track.
• Locate the S5 cable guide nipple over the middle 5mm hole in the
cable-port bridge, and push firmly to secure the guide in place.
When seated properly, the guide should sit flush with the bottom
bracket shell.
Cervélo S5 Supplementary Manual 18