Advertisement
MOUNTING:
1. Find a suitable location on the trunk lip or license plate bezel to secure the camera down to
the body of the vehicle
2. Make sure the mounting location that you choose is on a flat surface so that when the camera
is installed there will be no uneven gaps around the edges.
3. Use the supplied hole-saw bit to drill the hole of the camera's insert mounting clip. Use the
attached 3M double-side tape to secure the camera into place. The tape will also seal any
edges around the drilled hole for the insert.
4. Route the wire harness through the rear bumper of the vehicle or through any kind of rubber
grommet on the vehicle. If you have to drill a hole, make sure to seal the hole once you route
the wiring through to prevent leaking or moisture damage.
NOTE: Make sure to use the supplied hole-saw bit to drill the hole for the insert. This will help you
to avoid any mistakes in drilling the hole too big or too small.
Use the Provided Hole Saw
Bit to Drill the Hole for the Camera
REVERSE (MIRROR) IMAGING:
The SV-6818.EM.II Camera has built-in circuitry to "mirror" the image so objects on the right of
vehicle appear on the right and objects on the left appear on the left when looking at a standard
monitor. If your existing monitor or in-dash monitor has a reverse camera input where the monitor
itself performs the mirror image, then your picture will not be correct. If this happens, the SV-
6818.EM.II camera has wire that can be cut reverse the image back to normal. (See Wiring Diagram)
INSTALLATION
Cable
Mounting
Surface
Camera Lens
Mounting Clip
Double Side
Tape
Advertisement
