Advertisement
WIRING INSTRUCTION
(1) WARNING isolate the power supply. An internal
single pole wall switch is recommended to allow
easy control of the Spotlight.
(2) Remove the wall box screw at the base of the unit (if
fitted retain the screw for later use).
(3) Detach the wall box by using a flathead screwdriver
to gently pry the wall box open. There are two clips;
one on the left side and one on the right side of the
wall box. (FIGURE 4a & 4b)
FIGURE 4a
(4) Use a braddle to punch a small hole in the cable
grommet, enabling the supply cable to enter the wall
box.
(5) Route the supply cable through the cable grommet.
A drip loop is required between the wall box and the
wall to avoid water ingress.
(6) Determine the correct location to mount the Spotlight.
Use the wall box as a template to mark the fixing
holes on the wall. Drill the holes and insert the
plastic wall plugs supplied. Fix the wall box using the
screws provided. (FIGURE 5)
FIGURE 5
(7) Strip approximately 6-8mm of inner core insulation
from the supply cable.
(8) Connect the BROWN wire (Live wire) to the terminal
marked "L".
Connect the BLUE wire (Neutral wire) to the terminal
marked "N". (FIGURE 6)
NB: The Spotlight is double insulated no earth is
required.
FIGURE 4b
Fix the Cable Fastener into place to secure the cable.
(FIGURE 6)
(9) Refit the Spotlight onto the wall box and secure with
the two clips. Refit the wall box screw at the base of
the unit (if fitted).
Note: If you need to detach the Spotlight from the wall
box. WARNING isolate the power supply. Remove the
wall box screw at the base of the unit (if fitted). Detach
the wall box by using a flathead screwdriver to gently pry
the wall box open. There are two clips; one on the left
side and one on the right side of the wall box. (FIGURE 7).
Support the fitting during the process to prevent it from
falling.
ANGLE ADJUSTMENTS
The LED spotlight heads can be adjusted up to 45° left
and 45° right. The PIR sensor can be adjusted up to 45°
left and 45° right. (FIGURE 8a)
FIGURE 8a
The LED spotlight heads can be adjusted 37.5° vertically.
The PIR sensor can be adjusted vertically 35°
(FIGURE 8b)
2
LIVE
NEUTRAL
Cable Fastener
AC POWER
FIGURE 6
1
2
FIGURE 7
Advertisement
