Table of Contents
Advertisement
STEP-BY-STEP ASSEMBLY
Before starting to assemble this kit, read the "Kit Builders
Guide" for complete information on wiring, soldering, and
step-by-step assembly procedures.
The illustrations in this section of the Manual are called
Pictorials and Details. Pictorials show the overall operation
for a group of assembly steps; Details are used in addition to
the Pictorials to illustrate a single step. When you are
directed to refer to a certain Pictorial "for the following
steps," continue using that Pictorial until you are referred to
another Pictorial for another group of steps.
86 through 89) from time to time to sethe actual positions
of wires and components.
Lockwashers and nuts will be used with most screws when
mounting parts, unless the assembly steps state otherwise.
Consequently, the applicable steps will call out only the size
and type of hardware used. For example, the phrase "Use
6-32
x
114"
hardware" means to use
6-32
x
114"
screws, one
or more #6 lockwashers, and 6-32 nuts. Refer to the Details
for the proper installation of hardware. Be sure to position
each part as shown in the Pictorials. Follow the instructions
carefully, and read the entire step before performing the
operation.
As ,the drawings in the Manual may be slightly distorted to
When a step directs you to "connect" an insulated wire, first
show all the parts clearly, look at the Chassis Photos (Pages
prepare i t s ends by removing
114"
of insulation.
Hide quick links:
Advertisement
Table of Contents
