Samsung HPS5053X/XAA (HP-S5053) Service Manual page 92

Operation Instruction & Installation
11-3-4 Fixing the TV panel to the wall attachment panel bracket
Remove the screws from the back of the PDP.
1
Use the screw and assemble the plastic hanger. (Please refer to the following picture.)
2
• Please ask the installers to install the wall mount bracket.
• Please be sure to check if the plastic hanger is completely secured on both the left and
right side after hanging the SET on the wall mount bracket.
• Please avoid catching your fingers while installing and adjusting the angle.
• Please tightly secure the wall mount bracket to the wall to avoid injury from a falling SET.
Tighten the screws of the plastic hanger
3
(shown in picture 2) to the back side of
the PDP.
11-8
Remove the Safety Pins. Fasten the 4
4
plastic latches assembled at step ( ) on
the back side of the PDP using the guide
holes of the wall mount, push ( ) and
hook ( ) down to secure the PDP on
the wall mount as illustrated. Secure the
PDP by inserting the Safety Pins, not to
fall from the wall mount.
PDP
Wall Bracket Wall
Samsung Electronics